ABB REG670 - Mounting Procedure for 19 Panel Rack Mounting

21.4.2.2 Mounting procedure for 19” panel rack mounting
1a
IEC08000160-3-en.vsdx
1a
2
3
IEC08000160 V3 EN
Figure 557: 19” panel rack mounting details
The required torque for the screws is 3.5 Nm.
Pos Description Quantity Type
1a Mounting angles, which can be mounted, either to the
left or right side of the case.
2 -
2 Screw 8 M4x6
3 Washer 8 M4x6
1MRK502052-UEN B Section 21
IED hardware
1209
Technical manual