The high closing and carrying current capability allows connection directly to breaker
trip and closing coils. If breaking capability is required to manage fail of the breaker
auxiliary contacts normally breaking the trip coil current, a parallel reinforcement is
required.
For configuration of the output signals, refer to section
"Signal matrix for binary
outputs SMBO".
xx00000299.vsd
2
1
3
Output module
IEC00000299 V1 EN
Figure 530: Relay pair example
1
Output connection from relay 1
2 Output signal power source connection
3 Output connection from relay 2
Section 21 1MRK502052-UEN B
IED hardware
1162
Technical manual
To Next Page
Loading...
