ABB REG670 - Page 25

Settings......................................................................................767
Operation principle.................................................................... 767
Generic communication function for Double Point indication
DPGAPC........................................................................................ 768
Identification.............................................................................. 768
Functionality.............................................................................. 768
Function block........................................................................... 768
Signals.......................................................................................768
Settings......................................................................................769
Operation principle.................................................................... 769
Single point generic control 8 signals SPC8GAPC........................ 769
Identification.............................................................................. 769
Functionality.............................................................................. 769
Function block........................................................................... 770
Signals.......................................................................................770
Settings......................................................................................770
Operation principle.................................................................... 771
AutomationBits, command function for DNP3.0 AUTOBITS.......... 771
Identification.............................................................................. 771
Functionality.............................................................................. 772
Function block........................................................................... 772
Signals.......................................................................................772
Settings......................................................................................773
Operation principle.................................................................... 788
Single command, 16 signals SINGLECMD.................................... 788
Identification.............................................................................. 788
Functionality.............................................................................. 788
Function block........................................................................... 789
Signals.......................................................................................789
Settings......................................................................................790
Operation principle.................................................................... 790
Section 15 Logic.............................................................................791
Tripping logic common 3-phase output SMPPTRC .......................791
Identification.............................................................................. 791
Functionality.............................................................................. 791
Function block........................................................................... 791
Signals.......................................................................................792
Settings......................................................................................793
Operation principle.................................................................... 793
Logic diagram.......................................................................794
Technical data........................................................................... 798
Trip matrix logic TMAGAPC........................................................... 798
Identification.............................................................................. 798
Table of contents
19
Technical manual