C-bit Frame OverheadC-bit Frame Overhead
X F1 AIC F0 NA F0 FEAC F1
X F1 UDL F0 UDL F0 UDL F1
P F1 CP F0 CP F0 CP F1
P F1 FEBE F0 FEBE F0 FEBE F1
M0 F1 DL F0 DL F0 DL F1
M1 F1 UDL F0 UDL F0 UDL F1
M0 F1 UDL F0 UDL F0 UDL F1
AIC: Application Identification
NA: Network Application
FEAC: Far-End Alarm and Control
UDL: User Data Link
CP: C-bit Parity
FEBE: Far-End Block Error
DL: Data Link
Pattern typePattern type
Select the pattern to be inserted in the transmitted signal. Refer to Pattern type
in "E1 Setup and Status". Available patterns are:
OffOff
User [32] bitUser [32] bit, User [2048] bitUser [2048] bit
PRBS 9PRBS 9 to PRBS 31PRBS 31
QRSS 20QRSS 20
Fox PatternFox Pattern, Fox (CMA3000)Fox (CMA3000)
All 0'sAll 0's, All 1'sAll 1's
Alternating 1:1Alternating 1:1, Alternating 1:3Alternating 1:3, Alternating 1:7Alternating 1:7, Alternating 3:24Alternating 3:24
Touch 'Normal' or 'Inverse' pattern type.
Touching the 'ANSI standard' button will apply ANSI/IEEE 1007
recommended Pattern typePattern type for 45 Mbit data rates (PRBS 23 Inverse).
User patternUser pattern
User pattern field is enabled if Pattern type is set to User [32] bitUser [32] bit or User [2084]User [2084]
bitbit. Touch the User patternUser pattern field and use the launched Pattern EditorPattern Editor dialog box
to define the user pattern. Depending on the selected pattern type, different
user pattern setup options will be available.
The length can be any length from 1 bit to 32 bits or from 1 bit to 2048 bits.
FEAC CodeFEAC Code
When 'Frame type' is set to C-BitC-Bit, allows you to specify the six bits of FEAC
(Far-End Alarm and Control) channel code.
To Next Page
Loading...
