SetupSetup
Select this check box to enable statistics of the quality level reported in the
received ESMC (Ethernet Synchronization Messaging Channel) messages and
the generation of Sync Alarm when such messages are missing.
Due to the properties of 10 Mbps Ethernet, the transfer of SyncE timing cannot be
guaranteed at this rate.
FollowsFollows
It is possible to let the Port 2 copy the setup from Port 1 by touching the
FollowFollow button. When this button is displayed in green, Port 2 continues to
follow Port 1 change. This button appears when the Port 1 settings can be copy
to Port 2.
ModeMode
Non-sync/MonitorNon-sync/Monitor: Does not transmit an ESMC message.
SynchronousSynchronous: Forces the quality levels specified in
QL
to be transmitted in an
ESMC message every second.
Ql TypeQl Type
Allows you to select a protocol/option. This changes the textual representation
of the quality levels on the result- and status pages.
QlQl
Allows you to specify the quality level to be indicated in the transmitted
Ethernet signal.
Combination of Ql Type and QlCombination of Ql Type and Ql
G.781 G.781
option Ioption I
G.781 G.781
option IIoption II
G.781 G.781
option IIIoption III
G.8264G.8264
QL-INV0 QL-STU QL-UNK QL-INV0
QL-INV1 QL-PRS QL-INV1 QL-INV1
QL-PRC QL-INV2 QL-INV2 QL-INV2
QL-INV3 QL-INV3 QL-INV3 QL-INV3
QL-SSU-A QL-TNC QL-INV4 QL-INV4
QL-INV5 QL-INV5 QL-INV5 QL-INV5
QL-INV6 QL-INV6 QL-INV6 QL-INV6
QL-INV7 QL-ST2 QL-INV7 QL-INV7
QL-SSU-B QL-INV8 QL-INV8 QL-INV8
QL-INV9 QL-INV9 QL-INV9 QL-INV9
QL-INV10 QL-ST3 QL-INV10 QL-EEC2
QL-SEC QL-INV11 QL-SEC QL-EEC1
QL-INV12 QL-SMC QL-INV12 QL-INV12
QL-INV13 QL-ST3E QL-INV13 QL-INV13
QL-INV14 QL-PROV QL-INV14 QL-INV14
QL-DNU QL-DUS QL-INV15 QL-INV15
To Next Page
Loading...
