Allows you to specify a loss threshold that is used when an LMM test is active.
If the loss ratio meets or exceeds that threshold, the user is alerted.
SLM tab pageSLM tab page
The SLMSLM tab page contains the following parameters:
RateRate
Use the drop-down menu to select the rate at which SLM frames are
transmitted.
Frames to sendFrames to send
Allows you to specify the number of frames to transmit.
Loss thresholdLoss threshold
Allows you to specify a loss threshold that is used when an SLM test is active. If
the loss ratio meets or exceeds that threshold, the user is alerted.
EXM tab pageEXM tab page
The EXMEXM tab page contains the following parameter:
DataData
Allows you to specify a string which you can send in a message to other remote
maintenance points.
VSM tab pageVSM tab page
The VSMVSM tab page contains the following parameter:
DataData
Allows you to specify a string which you can send in a message to other remote
maintenance points.
Discovery view (802.1ag/Y.1731 protocols)Discovery view (802.1ag/Y.1731 protocols)
Touching the DiscoveryDiscovery button available for the 802.1ag or Y.1731 protocol
will display the screen shown below.
To Next Page
Loading...
