Discovering devicesDiscovering devices
Adding devicesAdding devices
manuallymanually
The contents of the Discovery view screen is the same for both protocols. The
screen contains the following parameters:
CCM/LBMCCM/LBM
Select the radio button for the relevant method of discovery.
CCMCCM - Passive method. Discover Remote Maintenance points by looking at
incoming CCM frames. This is the preferred method of discovery and the
default selection.
LBMLBM - Active method. Discover other devices by sending out a multicast
loopback message and discover the devices' MAC addresses.
Discovery intervalDiscovery interval
Use the drop-down menu to specify the time period during which to wait and
discover messages.
Max discovered devicesMax discovered devices
Allows you to specify the maximum number of devices that will be discovered.
To discover devices, touch the DiscoverDiscover button on the left side of the screen.
This will display the DiscoveryDiscovery dialog box.
Devices will appear in the dialog's list as they are discovered. Select the device
in the list and touch the AddAdd button in the dialog box. The device is added to
the list displayed on the Discovery view screen.
To add devices manually, touch the AddAdd button on the left side of the
Discovery view screen. This will launch the Add RmpAdd Rmp dialog box where you
can enter identification data for a specific remote device.
To Next Page
Loading...
