MTU DiscoveryMTU Discovery
Baseline RTTBaseline RTT
This screen allows you to specify test parameters.
The field will be enabled if Path MTU check box is selected on "Control"
screen.
Touch the Minimum MTUMinimum MTU or Maximum MTUMaximum MTU fields set the bytes range used
when discovering MTU.
The field will be enabled if Baseline RTT check box is selected on "Control"
screen. Touch the fields to set the running time of the Baseline RTT test.
66..1010..22..33 Windows Scan / ThroughputWindows Scan / Throughput
Windows Scan / ThroughputWindows Scan / Throughput button in the navigation area is enabled if
Windows Scan and Throughput check box of Test Sequence is selected on
"Control" screen.
The contents of the screen depend on the test mode selected on "Control"
screen.
The arrow buttons in navigation area switch the test direction of settings. The
right arrow button shows to Local -> RemoteLocal -> Remote direction, and left arrow button
shows Remote -> LocalRemote -> Local direction.
If AutoAuto is selected on "Control" screen, following screen appears.
To Next Page
Loading...
