Anritsu MT8820A - Ending a Call

5.4 Connecting a Call
5-9
5.4.2 Ending a call
Ending a call means terminating communication status between MT8820A and the
phone being tested and putting them into idle status. A call can be ended from
MT8820A (network) or from the phone, just as when connecting a call.
Note:
To end a call, the call processing status must be in communication. The term
indicating communication status varies depending on the measurement soft-
ware.
(1) Ending from MT8820A
Perform the following procedures to end a call from MT8820A:
[Procedure]
1. Check that the call-processing status is in communication (calling).
2. Press
End Call
on the front panel.
(2) Ending from the phone
Perform the following procedures to end a call from a phone
[Procedure]
1. Check that the call-processing status is in communication (calling).
2. Press the
Hold
button on the phone, or perform the equivalent operation.