Anritsu MT8820A - Extended Event Status Commands; Initialization Commands; Measurement Software Selection Commands

8.1 Command List by Function
8-5
8.1.2 Extended event status commands
The status report commands specific to MT8820A are listed in the table below. The commands are available on all screens.
Table 8-1-2-1 Extended event status commands
Function Command Query Response Remarks
End Event Status Enable Register Command ESE2 register ----- -----
End Event Status Enable Register Query ----- ESE2? register
End Event Status Register Query ----- ESR2? register
Error Event Status Enable Register Command ESE3 register ----- -----
Error Event Status Enable Register Query ----- ESE3? register
Error Event Status Register Query ----- ESR3? register
8.1.3 Initialization commands
The commands for initializing MT8820A are listed in the table below. The commands are available on all screens.
Table 8-1-3-1 Initialization commands
Function Command Query Response Remarks
RESET ----- -----
*RST ----- -----
PRE ----- -----
IP ----- -----
Reset
INI ----- -----
8.1.4 Measurement Software selection commands
Table 8-1-4-1 Measurement Software selection commands
Function Command Query Response Remarks
W-CDMA STDSEL WCDMA WCDMA
GSM STDSEL GSM GSM
CDMA2000 STDSEL CDMA2K CDMA2K
Measurement Software
PDC STDSEL PDC
STDSEL?
PDC