Section 5 Using Common Functions
5-12.
5.6.5 Setting a processing at an error occurrence
Sets a processing for the case when an error occurred.
(1) Normal mode
Continues the processing for succeeding commands ignoring an occurrence of
an error. An error pup-up window for the occurred error is displayed only at
the error occurrence, but deleted when the succeeding command is processed.
(2) Error remain mode
Displays the error popup window until the next error occurred. If a new error
occurs for the succeeding command, an error pop-up window for it is displayed.
(3) Stop mode
When an error occurs, command processing is interrupted while an error pop-up
window is being displayed.
The manual control mode can be returned from any mode by pressing
Local
.
In this case, the displayed message is deleted.
Example of programming by remote control
REMDISP NORMAL /*Normal mode*/
REMDISP REMAIN /*Error remain mode*/
REMDISP STOP /*Stop mode*/
To Next Page
Loading...
