Anritsu MT8820A - Saving a File with Specified File Name

6.3 Saving Parameters
6-25
6.3.8 Saving a file with specified file name
Use the Parameter Save screen to save the parameter setting by specifying any file
name.
Example:
To save parameter information to the new file named “Example”:
[Procedure]
1. Press
Screen
to open the Screen Select popup window
2. Turn the encoder to move the cursor onto “Parameter Save”.
3. Press the encoder to open the Parameter Save screen.
4. Turn the encoder to move the cursor in the file list onto “Create New File”.
5. Press the encoder to open the popup window for entering a new file name.
6. Turn the encoder to move the cursor onto “E”.
7. Press the encoder to enter “E” in the “File Name” column.
8. Also, enter “x”, “a”, “m”, “p”, “l”, and “e” in the same way.
9. Press
Set
to start saving.
Example of programming by remote control
PRMSAVENAME "Example"
If a file of the same name exists, the overwrite confirmation popup window opens.
To overwrite, press “OK”. To change the file name, place the cursor onto “Cancel”
and press the encoder.
Note:
During remote control, overwrite confirmation and other operations are not
performed. To prevent important data from being overwritten, use the de-
fault file name for saving under remote control.