Section 7 Remote Control Using PC
7-22
7.6.5 Service request enable register
The service request enable register sets the contents of which bit of the status byte
register occurs, to set MSS (bit 6) of the status byte (to 1).
Each bit of the service request enable register corresponds to contents of each bit of
the status byte register (however, bit 6 is not used.)
Setting
Set the service request enable register by using the *SRE command. The
parameter is the decimal value converted from the sum of the values obtained by
binary-weighing the specified event.
Example:
To set MSS bit to 1 when ERR event has occurred:
*SRE 8 /*2
3
= 8 is set because ERR is bit 3*/
Query
Read using the *SRE? command. Response is the decimal value converted from
the sum of the values obtained by binary-weighing the specified bits.
Clear
The following methods are available to clear the service request enable register:
• Send the *SRE 0 command
• Turn the power On
To Next Page
Loading...
