6.1 Setting Systems and Interfaces
6-13
6.1.9 Setting the beep sound
Beep sound emitted at the error of setting operation can be set. It is set to On by de-
fault.
Example:
To set the beep sound to Off
[Procedure]
1. Press
Config
to open the Configuration menu.
2. Press
F1
: System Config. to open the System Configuration screen.
3. Turn the encoder to move the cursor onto “Beep Sound”.
4. Press the encoder to open the popup window.
5. Turn the encoder to “Off”.
6. Press the encoder to determine the value.
Example of programming by remote control
ALARM OFF
6.1.10 Setting the signal output connector
Set whether the RF signal of MT8820A is output from the main input/output con-
nector (Main) or from the auxiliary output connector (AUX). The signal output to
Phone-1 is output from the RF1 connector.
The signal output connector is set in any of the following ways:
(1) Opening the Configuration menu from any screen for setting
(2) Use the System Configuration screen for setting
Opening the Configuration menu from any screen for setting RF output connector
[Procedure]
1. Press
Config
to open the “Configuration” menu.
2. Press
F2
: RF-1 Config. to open the “RF-1 Configuration” popup window.
3. Turn the encoder to move the cursor onto “RF Output”.
4. Press the encoder to open the popup window.
5. Turn the encoder to move the cursor onto the connector that outputs the RF sig-
nal.
6. Press the encoder to determine the value.
7. Turn the encoder to move the cursor onto “Close”.
8. Press the encoder to close the popup window.
To Next Page
Loading...
