Anritsu MT8820A - Page 185

7.6 Status Report
7-27
Table 7-6-8-2 Description of each bit of ERR event status register
When using CDMA2000 measurement software
Bit Description
7 Not used
6 Call Drop Error
Occurs when the MT8820A can’t demodulate signal of phone.
5 Not used
4 Call Processing Error
Indicates that an error has occurred during call processing.
3 Reception Measurement Error
Indicates that an error has occurred during reception measurement.
2
Transmission Measurement Error
Indicates that an error has occurred during transmission measurement,
except for Access Prove Power.
1 Access Prove Power Measurement Error
Indicates that an error has occurred during measurement for Access
Prove Power on the Fundamental Measurement screen.
0 Not used
 Query
Read using the ESR3? query. When readout is successful, the contents of the
register are cleared.
Example:
Query ESR3?
Response 80
(80 = 2
4
+ 2
6
: bit 4 and bit 6 errors have occurred)
 Clear
The following methods are available to clear the ERR status register:
• Read the status using the command
• Send the *CLS command
• Turn the power On