8.2 Command Specifications in Alphabetical Order
8-57
S2
Measure - Single
Starting measurement in single mode
Function
Starts measurement in single mode.
Command
S2
Query
None
Response
None
Description
When MT8820A receives the next command during measurement (started with the
S2 command), the measurement stops and processing for the next command starts.
To allow processing for the next command after measurement is over; use the SWP
command, instead of S2 command.
Sample programming
To start measurement in single mode:
S2
Related commands
SNGLS : Same function as S2
SWP : Starting measurement in synchronous single mode
TS : Starting measurement in synchronous single mode
To Next Page
Loading...
