ARM ARM7TDMI - Table 7-8 Unidirectional Data Read Cycle Timing Parameters; Figure 7-8 Unidirectional Data Read Cycle; Figure 7-9 Configuration Pin Timing

AC and DC Parameters
ARM DDI 0210C Copyright © 2001, 2004 ARM Limited. All rights reserved. 7-9
Figure 7-8 Unidirectional data read cycle
The timing parameters used in Figure 7-8 are listed in Table 7-8.
Figure 7-9 Configuration pin timing
MCLK
nENOUT
DIN[31:0]
T
nen
T
disu
BL[3:0]
T
bylh
T
byls
T
dihu
Table 7-8 Unidirectional data read cycle timing parameters
Symbol Parameter Parameter type
T
bylh
BL[3:0] hold time from MCLKfMinimum
T
byls
BL[3:0] set up to from MCLKrMinimum
T
dihu
DIN[31:0] hold time from MCLKfMinimum
T
disu
DIN[31:0] set up time to MCLKfMinimum
T
nen
MCLKf to nENOUT valid Maximum
T
cth
T
cts
T
cts
T
cth
MCLK
BIGEND
ISYNC