ARM ARM7TDMI - Table 7-18 Scan General Timing Parameters; Figure 7-18 Scan General Timing

AC and DC Parameters
7-16 Copyright © 2001, 2004 ARM Limited. All rights reserved. ARM DDI 0210C
Figure 7-18 Scan general timing
The timing parameters used in Figure 7-18 are listed in Table 7-18.
T
msd
MCLKf to nMREQ and SEQ valid Maximum
T
wh
nWAIT hold from MCLKfMinimum
T
ws
nWAIT setup to MCLKrMinimum
Table 7-17 MCLK timing parameters (continued)
Symbol Parameter Parameter type
T
bsss
T
bssh
T
bsod
T
bsih
T
bsis
T
bscl
T
bsch
T
bsoh
T
bsdh
T
bsdd
T
bsdh
T
bsdd
TCK
TMS
TDI
TDO
Data in
Data out
Table 7-18 Scan general timing parameters
Symbol Parameter Parameter type
T
bsch
TCK high period Minimum
T
bscl
TCK low period Minimum
T
bsdd
TCK to data output valid Maximum
T
bsdh
Data output hold time from TCK Minimum
T
bsih
TDI, TMS hold from TCKrMinimum
T
bsis
TDI, TMS setup to TCKrMinimum
T
bsod
TCKf to TDO valid Maximum