11-12 BE1-951 ASCII Command Interface 9328900990 Rev L
RA-MIN Command
Purpose: Report/Reset Minor Alarm information
Syntax: RA-MIN[=0]
Example: RA-MIN or RA-MIN=0
Reference: Section 6, Reporting and Alarm Functions, Alarms Function
RA-REL Command
Purpose: Report/Reset Relay Alarm information
Syntax: RA-REL[=0]
Example: RA-REL or RA-REL=0
Reference: Section 6, Reporting and Alarm Functions, Alarms Function
RB Command
Purpose: Read breaker status
Syntax: RB
Example: RB
Reference: Section 6, Reporting and Alarm Functions, Breaker Monitoring
RB-DUTY Command
Purpose: Read/Set breaker contact Duty Log
Syntax: RB-DUTY[{phase}[={%duty}]] where %duty is % of dmax set with SB-DUTY;
Example: RB-DUTYA or RB-DUTYB=50
Reference: Section 6, Reporting and Alarm Functions, Breaker Monitoring
RB-OPCNTR Command
Purpose: Read/Set Breaker Operation Counter
Syntax: RB-OPCNTR[={#operations}]
Example: RB-OPCNTR=32 or RB-OPCNTR=652
Reference: Section 6, Reporting and Alarm Functions, Breaker Monitoring
RD Command
Purpose: Report all demand data
Syntax: RD
Example: RD
Reference: Section 6, Reporting and Alarm Functions, Demand Functions
RD-PI Command
Purpose: Read/Reset peak demand current (I)
Syntax: RD-PI[{p}[=0]] where p=A/B/C/N/Q
Example: RD-PI or RD-PIA or RD-PIN or RD-PI=0
Reference: Section 6, Reporting and Alarm Functions, Demand Functions
RD-PVAR Command
Purpose:
Read/Reset peak demand vars
Syntax: RD-PVAR[=0,0] - Fwd,Rev Var Flow
Example: RD-PVAR or RD-PVAR=0,0
Reference: Section 6, Reporting and Alarm Functions, Demand Functions
RD-PWATT Command
Purpose: Read/Reset peak demand watts
Syntax: RD-PWATT[=0,0] - Fwd,Rev Power Flow
Example: RD-PWATT or RD-PWATT=0,0
Reference: Section 6, Reporting and Alarm Functions, Demand Functions
To Next Page
Loading...
Need help?
General