Basler BE1-951 - Programmable Logic Setting Commands

11-20 BE1-951 ASCII Command Interface 9328900990 Rev L
Programmable Logic Setting Commands
SL Command
Purpose: Obtain Setting Logic Information
Syntax: SL:[{name}]
Example: SL, SL: or SL:BASIC-OC
Reference: Section 11, ASCII Command Interface, Settings (S) Command Descriptions
SL-24 Command
Purpose: Read/Set Logic for 24 Function Modules
Syntax: SL-24[={mode},{BLK logic}]
Example: SL-24 or SL-24=1,0 or SL-24=1,IN3
Reference: Section 4, Protection and Control, Voltage Protection
SL-25 Command
Purpose: Read/Set Logic for 25 Function Modules
Syntax: SL-25[={mode},{BLK logic}]
Example: SL-25 or SL-25=1,0 or SL-25=1,IN3
Reference: Section 4, Protection and Control, Synchronism-Check Protection
SL-27 Command
Purpose: Read/Set Logic for 27 Function Modules
Syntax: SL-{f}27[{p}[={mode},{BLK logic}]] where f= 0/1 and p=P/X
Example: SL-27 or SL-27P=1,0 or SL-27X=3,0 or SL-27P=1,IN3
Reference: Section 4, Protection and Control, Voltage Protection
SL-32 Command
Purpose: Read/Set Logic for 32 Function Modules
Syntax: SL-32[={mode},{BLK logic}]
Example: SL-32 or SL-32=1,0 or SL-32=1,IN3
Reference: Section 4, Protection and Control, Directional Power Protection
SL-43 Command
Purpose: Read/Set Logic for Virtual switch (x43)
Syntax: SL-{x}43[=mode] where x = blank/1/2/3, mode=0/1/2/3
Example: SL-43 or SL-143=0 or SL-243=1
Reference: Section 4, Protection and Control, Virtual Switches
SL-47 Command
Purpose: Read/Set Logic for 47 Function Modules
Syntax: SL-47[={mode},{BLK logic}]
Example: SL-47 or SL-47=1,0 or SL-47=1,IN3
Reference: Section 4, Protection and Control, Voltage Protection
SL-50T Command
Purpose: Read/Set Logic for x50 Function Modules where x = blank or 1
Syntax: SL-x50T[{p}[={mode},{BLK logic}]] where p = P/N/Q
Example: SL-50T or SL-50T=1,0 or SL-150TN=1,IN3
Reference: Section 4, Protection and Control, Overcurrent Protection
SL-51 Command
Purpose: Read/Set Logic for 51 Function Modules
Syntax: SL-51[{p}[={mode},{BLK logic}]] where p=P/N
Example: SL-51 or SL-51P=1,0 or SL-51N=1,IN3 or SL-151N=1,0
Reference: Section 4, Protection and Control, Overcurrent Protection