9328900990 Rev L BE1-951 Terminal Communication C-3
Figure C-3. ASCII Setup Dialog Box
Step 9: HyperTerminal is now ready to communicate with the relay.
Table C-1 describes the required
connection for each RS-232 port.
Table C-1. RS-232 Communication Ports
Connection Type
Front Port 9-pin female DCE
PC to Front RS-232 port cable Straight
Rear Port 9-pin female DCE
PC to Rear RS-232 port cable Straight
WINDOWS
®
TERMINAL
Step 1: In Program Manager, open the Accessories program group and double click the Terminal icon to
start the program.
Step 2: On the menu bar, select Settings/Terminal Emulation.
a. In the dialog box, click DEC VT-100 (ANSI).
b. Click “OK”.
Step 3: Select Settings/Terminal Preferences.
a. Using
Figure C-4 as a guide, make the following selections in the dialog box:
Check the Line W
rap and Local Echo boxes to enable these functions.
Disable (uncheck) the CR ->CR/LF O
utbound function.
b. Set the Buffer Lines at 244.
c. Click “OK”.
Step 4: Select Settings/Text Transfers.
a. Make the following selections using
Figure C-5 as a guide:
Set Flow Control at L
ine at a Time.
Enable Delay B
etween Lines and set the delay at 1/19 or 2/10 seconds.
Disable Word W
rap…
b. Click “OK”.
To Next Page
Loading...