Parameter Description
Sharpness
Adjusts the sharpness of image edge. The bigger the value is, the
more obvious the image edge is. Adjusts the sharpness according
to actual environment.
Gamma
It is to adjust image brightness and enhance the image dynamic
display range. The bigger the value is, the more bright the video is.
Mirror
Enable the function, the left and right side of the video image will
be switched. It is disabled by default.
This function is for some series products only.
Flip
It is to set monitor video display direction. It includes Normal, 180°,
90°, 270°.
Exposure
Auto Iris
● It is for the camera of auto iris only.
● After enable auto iris function, the iris can
automatically zoom in/zoom out according to
the brightness of the environment and the
image brightness changes too.
● If disable the auto iris function, the iris does
not automatically zoom in/zoom out
according to the brightness of the
environment when the iris is at the biggest
value.
3D NR
This function specially applies to the image
which frame rate is configured as 2 at least. It
reduces the noises by making use of the
information between two frames. The bigger the
value is, the better the effect.
Backlight Mode
You can set camera Backlight mode.
● SSA: In the backlight environment, the system can
automatically adjust image brightness to clearly display the
object.
● BLC:
◇
Default: The device auto exposures according to the
environments situation so that the darkest area of the video
is cleared.
◇
Customize: After select the specified zone, the system can
expose the specific zone so that the zone can reach the
proper brightness.
● WDR: In backlight environment, it can lower the high bright
section and enhance the brightness of the low bright section.
So that you can view these two sections clearly at the same
time.
● HLC: In the backlight environment, it can lower the brightness
of the brightest section and reduce the area of the halo and
lower the brightness of the whole video.
● Stop: It is to disable the BLC function.
Copyright © NSS Sp. z o.o.
51 User‘s Manual
To Next Page
Loading...