ekrPro Com
60
web guide controller EDV No.: MD.191.01.05/1.6.x
with analog sensors Date: 23.11.2007 Page: 2/2
B 3.7 Set-up menu B3-26
B 3.7.1 Change User - User level selection B3-26
B 3.7.2 Material Setup - Sensor compensation B3-26
B 3.7.3 Sel. Std. System - Selection of a standard system B3-26
B 3.7.4 Save/Load settings- Load or save settings B3-26
B 3.7.5 General Set-up - System parameters B3-27
B 3.6.4.1 Setting the default values B3-27
B 3.6.4.2 Actuator –Actuator settings B3-28
B 3.6.4.3 Sensors/EFE - Commissioning sensors and EFE B3-35
B 3.6.4.4 Control Loop - Control loop settings B3-37
B 3.6.4.5 FVG - Sensor positioning device B3-38
B 3.6.4.6 Width Measure - Web width measurement B3-50
B 3.6.4.7 Edge Sources - Assignment of the sensors B3-54
to the guiding modes
B 3.6.4.8 Add. Functions - Special functions B3-56
B 3.6.4.9 Dig. IO Config. - Configuration of the digital B3-60
inputs and outputs
B 3.6.4.10 Special - Special device settings B3-69
B 3.6.5 Opt. Logic - Optional logic B3-72
B 3.6.6 Fieldbus - Field bus B3-72
B 3.6.7 Remote Device - Commissioning with a CAN bus B3-73
B 3.6.8 Test - Test program for service purposes B3-74
B 4 Terminal assignments and service displays B4-1
B 4.1 Board overview B4-1
B 4.2 Terminal diagrams B4-2
B 4.3 Service indicator displays B4-9
To Next Page
Loading...
