Note
The document types other than Auto scan are Document and Photo. If you select other
than Auto scan, you can save scanned data on the computer according to the settings
you specified for Scan size, Data format, and Scan resolution available by pressing the
Settings
button.
For details, refer to the on-screen manual:
.
2.
Load an original on the Platen Glass or in the ADF.
See
Loading Originals.
For details on the types and sizes of the original which can be scanned, see
Originals You Can Load
.
Note
Characters and lines written with a light colored pen or highlight pen may not be scanned
properly.
3.
Press the
Color
or
Black
button to start scanning.
MP Navigator EX will be started, and the scanned data will be saved on the computer according to the settings
specified with MP Navigator EX.
Scanning.. will appear while scanning the original.
When scanning from the Platen Glass, the machine automatically detects whether the type of a scanned data is
photo or document and the scanned data is saved to a single file on the computer according to the settings
specified with MP Navigator EX (JPEG/Exif, TIFF, PDF).
When scanning from the ADF, the scanned data is saved as a document on the computer. If PDF is specified for
the saving format in MP Navigator EX, all documents loaded in the ADF are saved to a single file.
Remove the original on the Platen Glass or the Document Output Slot after scanning is completed.
Important
Do not turn off the power while the machine is operating.
Do not plug in or unplug the USB cable while the machine is scanning originals with the
computer.
Do not open the Document Cover or move the loaded original until scanning is completed.
Note
The position or size of the original may not be scanned correctly depending on the type of
original.
If the scan is not performed correctly, try to scan again after selecting Document or Photo for
Document type and changing the settings of Scan size, etc. to match the original.
For details, refer to the on-screen manual:
.
When the program selection screen appears:
The program selection screen may appear after performing step 3.
If the program selection screen appears, select MP Navigator EX Ver4.1 and click OK.
To start MP Navigator EX automatically without displaying the program selection screen, follow
the procedure below.
- For Windows 7 or Windows Vista users, refer to "For Windows Users" in "
Troubleshooting
"
of the on-screen manual:
.
- For Windows XP users, select MP Navigator EX Ver4.1 as the software application to be
used in the program selection screen, select Always use this program for this action, then
click OK.
Page top
Seite 56 von 922 SeitenSaving Scanned Data to the Computer
To Next Page
Loading...
