Daedong DSC48 - REAPING UNIT

1. REAPING UNIT ....................................... 3-3
1.1 Sectional view .......................................... 3-3
1.2 Detachment and attachment of reaping unit
................................................................. 3-5
1.2.1 Detachment .................................... 3-5
1.2.2 Attachment ..................................... 3-5
1.3 Cutting blade unit ..................................... 3-6
1.3.1 Adjustment and replacement of cutting
blade unit .......................................... 3-6
1.3.2 Components related to cutting blade
crank ............................................... 3-8
1.3.3 Components related to cutting blade
drive case ....................................... 3-9
1.4 Elevator .................................................. 3-10
1.4.1 Adjustment of elevator chain tension
and replacement of elevator chain .. 3-10
1.4.2 Replacement of elevator rakes ..... 3-10
1.4.3 Elevator rake and cushion rubber
installation .................................... 3-11
1.4.4 Elevator drive 14 sprocket shaft, bear-
ing, 12 sprocket ............................ 3-11
1.4.5 Elevator shift case ........................ 3-12
1.5 Conveyor ................................................ 3-13
1.5.1 Adjustment and replacement of protru-
sion belt ........................................ 3-13
1.5.2 Adjustment and replacement of stem
side chain (RH) .............................3-13
1.5.3 Adjustment and replacement of stem
side chain (LH) ............................. 3-14
1.5.4 Adjustment and replacement of grain
side chain (LH) ............................. 3-14
1.5.5 Adjustment and replacement of grain
side chain (RH) ............................ 3-15
1.5.6 Adjustment and replacement of stem
side feeding chain ........................ 3-16
1.5.7 Adjustment and replacement of feed-
ing depth control chain ................ 3-17
1.5.8 Replacement of packer .............. 3-18
1.5.9 Installation of stem side conveyor
prop ............................................ 3-19
1.5.10 Large-diameter washer of stem side
support spring ............................ 3-19
1.5.11 Installation of chain lock plate .... 3-20
1.5.12 Installation of stem side prop ..... 3-20
1.5.13 Installation of feeding guide ...........3-21
1.5.14 Installation of feeding chain ............3-21
1.5.15 Installation of feeding depth control
chain .......................................... 3-21
1.5.16 Vertical adjustment of feeding depth
control chain ............................... 3-22
1.6 Other bolts and nuts, LOCTITE and grease
application .............................................. 3-23
TABLE OF CONTENTS
REAPING UNIT
DSC48