1
-4
Apr. 2007
DSC48
1.2 SPECIFICATIONS
Model DSC 48
Structural Quality Crawler self-propelled half-feed model
Dimensions Length (mm) 4,340
Width (mm) 1,780
Height (mm) 2,270
Toral weight (kg) 2,180
Engine Model 4A220C-CH
Type Water-cooled 4-cycle 4 cylinder in-line diesel
Displacement (cc) 2,197
Power/Revolutions KW / (r/min) 35.3 / 2,800
Fuel tank capacity (ℓ) CASE J1349 Gross intermittent
Driving Unit Crawler (Width x Length of ground contact) (mm) 49
Center distance of crawler (mm) 400 x 1.300
Average ground contact pressure (kpa) 1.000
Transmission 20.6
Minimum ground clearance (mm) Hydrostatic transmission (HST)
Driving speed (m/s) Forward 195
Reverse Low speed: 0~0.86,
Average: 0~1.22,
Drive: 0~1.65
Reaping unit Reaping width (mm) 1,450
Reaping rows 4
Stripper harvester with lifting device Hydraulic model
Reaping height (mm) 35 ~ 150
Allowable crop height (mm) 550 ~ 1,300
Allowable crop angle (degree) From rear: 85° or lower
From front: 70° or lower
Available speeds Synchronized 2 shifts for moving units + 3
speeds for elevation
Threshing units Threshing type Under feed threshing
Threshing rotor Diameter x Width (mm)
φ
424 x 800
Rotation speed (r/min)
φ
503
Grain separator Diameter x Width (mm)
φ
178 x 712
Revolution (r/min) 985
Sieve case Diameter x Width (mm)
φ
665 x 1,397
Separation methods Shaking, blowing and sucking
Grain outlet
units
Hopper Grain discharge type Gathering grains by hand
Capacity 200L (4)
straw discharge
units
Cutter
O
To Next Page
Loading...
