Daedong DSC48 - Initial 50 Hours

Apr. 2007
1
-19
DSC48
1.9.3 INITIAL 50 HOURS
A. CHANGING ENGINE OIL
1. Stop the engine. Then, drain the engine oil before it
gets cool. Drain the oil completely and then add the
specifi ed amount of oil through the inlet.
417W144A
(1) Drain plug
417W145A
(1) Oil Inlet
(2) Oil gauge
(A) Oil level is acceptable within this range
• Be sure to stop the engine before changing engine oil.
CAUTION
2. Replace the oil fi lter when changing the engine oil.
3. After changing the engine oil, start the engine, run it for
approx. 2 minutes and stop it. Then, check the oil level
again.
B. CHANGING TRANSMISSION FLUID
1. Remove the drain plug and drain the fl uid completely.
2. Remove the HST fi lter and hydraulic fi lter.
3. Install new fi lters. Thinly apply oil to the fi lters' gaskets.
4. Add oil to the specifi ed level through the oil inlet and
check the fl uid level with the level check bolt.
417W146A
(1) Oil inlet
(2) Level check bolt
(3) Drain plug
• Stop the engine before checking the transmission fl uid
level or changing the fl uid.
CAUTION
Temperature Oil type Capacity
15ºC or higher
Diesel engine oil 30 or
15W-40
8.0 ℓ
Below 15ºC Diesel engine oil 15W-40
Type Capacity
Daedong TF65 7.1 ℓ