Daedong DSC48 - REMOVAL OF TRANSMISSION CASE

Apr. 2007
5
-9
DSC48
D. REMOVAL OF OTHER COMPONENTS
1. Remove the cylinder pin and detach the reaping unit
cylinder.
<When assembling>
• Apply LOCTITE to the mounting bolt of the cylinder pin.
417W517A
2. Disconnect the parking brake cable from the left side
clutch lever and then right side clutch lever.
417W518A
1.2.7 REMOVAL OF TRANSMISSION
CASE
A. DETACHMENT OF REAPING UNIT:
see page 3-5
B. REMOVAL OF CRAWLER: see page 5-6
C. TRANSMISSION FLUID DRAIN
1. Open the fluid inlet cover and remove the fluid drain
plug to drain the transmission fl uid.
417W516A
• When adding oil
Remove the level check bolt (M8) and check whether
the oil comes out.
CAUTION
(1) Parking brake cable
(2) Side clutch lever
(1) Reaping unit cylinder
(1) Drain plug (3) Oil inlet
(2) Level check bolt