1
-36
Apr. 2007
DSC48
H. CHECKING SIEVE
• Check
Check if the sieve protrusion is worn or the welding sec-
tions on the sieve support and arch metal are damaged.
• Replacement (check every 600 hours)
If its wire diameter is 1.6 mm or less
417W192A
(A) 1.6 mm or less (new one: 2.6 mm)
417W193A
(1) No. 1 auger discharge blade
(2) No. 1 auger discharge blade 3
I. CHECKING NO. 1 AUGER DISCHARGE
BLADE
• Check
Check if it is worn or not properly installed.
• Replacement
If the blade is excessively worn or does not properly trans-
fer crops
J. REPLACING OIL SEAL (TRACK ROLLER
AND DRIVE SHAFT)
• Check
Check if dirt or foreign materials enter the seals or oil
leaks.
• Replacement
If dirt or foreign materials enter the seals or oil leaks
To Next Page
Loading...
