Dräger Apollo Operating Instructions

Overview Chapter 4 - System Setup
Apollo Operator’s Manual 39
Part Number: 90 38 237, 6th edition
Overview
This section of the manual provides information on
how to set up and install all system components
needed to prepare the Apollo for use. The setup
procedure shall be followed by the performance of
the Periodic Manufacturer’s Procedure.
Charging the Battery for
Emergency Operation
Apollo has a built-in uninterruptible power supply
(UPS) which maintains the power supply for at least
30 minutes (up to 90 minutes, depending on the
ventilation parameters) in the event of a mains power
failure, provided that the battery is fully charged.
Switching to battery power takes place automatically
and is indicated on the screen by the message:
POWER FAIL.
The battery recharges automatically when the
workstation is plugged into the mains, but only up to
a maximum ambient temperature of 95° F/35
o
C.
Figure 18. Location of AC Power LEDThe battery must be charged for 10 hours before
using the workstation for the first time:
1. Plug the mains power plug of the Apollo
workstation into the mains outlet. The mains
voltage must correspond to that specified on the
rating plate on the back of the machine.
The green LED labeled >
N AC Power< lights up
(1 in Figure 18).
2. Leave the Apollo connected to the mains for 10
hours. The workstation does not have to be
switched on.
WARNING !
Use only clean and disinfected parts to prevent
infection of patient or user.
1
Caution !
The devices connected to auxiliary power sockets
will not be powered by the UPS in the event of a
power failure.

Dräger Apollo Specifications

General

Brand	Dräger
Model	Apollo
Category	Medical Equipment
Language	English