Chapter 4 - System Setup Connecting AC Power
54 Apollo Operator’s Manual
Part Number: 90 38 237, 6th edition
If a circuit breaker is tripped (position 0):
1. Remedy the fault.
2. Press the switch on the circuit breaker into
position 1.
In cases of a blown safety fuse:
1. Remedy the fault.
2. Have the safety fuse replaced by an electrician.
Connecting the Apollo to Mains Power
Figure 36. Location of AC Power LEDThe mains voltage must correspond to that specified
on the rating plate on the back of the machine.
• Plug the mains power plug of the Apollo
workstation into the mains outlet. The green
LED labeled >
N AC Power< lights up (1 in
Figure 36).
Note: The main circuit breaker for the machine is
located on the back of the machine below
the pipeline connections and behind the
cylinder mounts (2 in Figure 34).
1
To Next Page
Loading...
Need help?
General
