Code display Cause Detection timing
E008
• The I/F PCB unit is defective.
• IPC I/F PCB unit is defective.
• During on-line platemaking, communication error
occurs between main PCB unit and I/F PCB unit.
E009
• The regulated power supply is defective.
• The thermal head substrate is defective.
• The thermal head is defective.
• At start of platemaking, thermal head drive voltage
does not reach regulation value.
E201 • A trouble occurs on the ADF.
• Refer to HELP21, communication information, error
information and ADF Service Manual.
E301 • Sorter A conveyance motor trouble.
• Refer to the Service Manual for the Sorter.
E302 • Sorter A bin unit motor trouble.
E303 • Sorter B conveyance motor trouble.
E304 • Sorter B bin unit motor trouble.
E305 • Sorter bridge motor trouble.
E306 • Sorter A stapler trouble.
E307 • Sorter B stapler trouble.
HELP mode H-21 \ see p.323
To Next Page
Loading...
Need help?
General