354
c HELP Mode Function and Operation Procedures
chap.7
H-52, H-57
(1) Adjustment / specification settingHELP mode
****
¡H-57:Line scannning speed
r
Press the Stop key.
t
To also select the data transmission speed (time for scanning of 1
line), carry out this step and the following 2 steps:
y
Use the [0] and [1] numeric keys to enter a new 4-place binary
value. See the table in wabove for 4-place binary values and the
corresponding settings.
- L -
During memorization:
i
Press the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
u
Press the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
To Next Page
Loading...
