Epson Stylus Pro 10000 - Page 327

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Stylus Pro 10600 Product Description 320

PG Setting
Selecting this mode allows the user to set the platen gap. The relationship between
panel setting, command setting (SN command), and actual platen gap position is
shown below.
NOTE1: (*1) When "Narrow" is set, "S" is displayed on the right side of LCD
(20 th character).
NOTE2: (*2) When "Wide" is set, "H" is displayed on the right side of LCD (20
th character).
 Page Lines
Selecting this mode allows the user to set the page line print mode. Setup is the
same as horizontal lines ON command (AC 02H 00H 00H 02H) with automatic
cutting setup. The solid line type is used.
 Interface Select
Selecting this mode allows selection of the parallel / USB, or optional interface-1 /
2, or automatic interface selection.
 Code Page Switching
Selecting this mode allows switching between PC437 and PC850 for the code
page.
 Roll Paper Margin
Setting this panel allows switching roll paper margin, all sides 3mm / all sides
15mm / top and bottom 15mm, right and left 3mm. This setting is only valid for
roll paper. It’s not valid for sheet.
 Detect Paper Width
It restrains "RELOAD PAPER" error in case detecting paper width is not
completed normally.
and prints with
 left edge of paper putting standard mark position on the paper guide
 print area designated by command
by PAPER SIZE CHK=OFF setting.
 Detect Skew Error
It restrains "PAPER NOT STRAIGHT" error and keeps printing by PAPER NOT
STRAIGHT=OFF setting.
NOTE: Even if the printing image is out of paper because the paper is not
straight by the setting, the printer doesn’t inform the error, so users have
to set it up.
 Job Timeout Setting
If print data is ceased while the printer is receiving print data and is receivable
print data longer than set time here, such is understood as job is finished and the
printer starts to eject paper.
 Panel Setup Value Initialization
Selecting this mode allows the user to return all Printer setup values to the default
values. Values to be initialized are listed below.
Table 8-7. PG Position
Paper
thickness
sensor
SN
command
Panel setup
Actual PG
position
Application Notes
Less than
0.6mm
Small
Narrow 1.4mm
Thick paper
*1
Standard 1.4mm
Thick paper
Wide 2.1mm
Reduce the smearing on the
printed image of thin paper.
*2
Middle
Narrow 1.4mm
Thick paper
*1
Standard 2.1mm
Reduce the smearing on the
printed image of thin paper.
Wide 2.6mm
Thin paper
*2
Big
Narrow 2.1mm
Reduce the smearing on the
printed image of thin paper.
*1
Standard 2.6mm
Thin paper
Wide 2.6mm
Thin paper
*2
- - 2.6mm
Thin paper
More than
0.7mm
- - 2.6mm
Thin paper
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com