Epson Stylus Pro 10000 - Page 342

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Stylus Pro 10600 Product Description 335
Hexadecimal Dump
The hex dump function allows data sent to the printer to be printed and displayed in
hexadecimal format.
Panel Display Language Select
Selecting this mode allows the user to select English, French, Italian, German, Spanish,
Portuguese for display on the LCD.
Switching units (only when English is selected)
Selecting this mode allows the user to select length units on panel LCD display and
pattern printing.
 METRIC: Meter
 FEET/INCHES: Feet (ft)/ Inch (in)
The message which can select a unit is shown in Table 8-19.
Parallel Interface mode
Selecting this mode allows the user to select receiving speed of parallel interface either
high speed or standard speed
IEEE1284.4 setup
This setup allows to switch on/off of IEEE1284.4 (Bi-directional transport) mode.
Internal Job Information setup
This setup allows to switch mode to save/not to save printer’s internal job (see below)
as job information.
NOTE: When HC2/AY ink is set, it is not displayed.
Auto nozzle check setup
Select Auto nozzle check OFF/ON.
The default is ON
Supersonic Cleaning
This mode executes supersonic cleaning.
NOTE: This menu indicates only on pigment model (HCD/PPI/HC2) and not on
dye model.
Table 8-19. Message which can Select a Unit
Item
Message
Meter Feet/Inch
Panel LCD display
Total paper used
xxxxx.xcm xxxxft xxin
Job information display
(paper used)
xxx.xxxm
2
xxxx.xxsqft
Nozzle check pattern
Current Paper Count
xxxxx.xcm xxxxft xxin
Prev. Paper Count
xxxxx.xcm xxxxft xxin
Status sheet Use Paper
xxxxxx.xcm xxxxft xxin
Job information printing
Paper used (vertical)
xxxxxxmm xxxxft xxin
Paper used (horizontal)
xxxxxxmm xxxxft xxin
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com