4. Troubleshooting
41000
3/7
41000
Attention message: Printer
If the test print color density is abnormal
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
Clean the advance rollers of the colorimeter with a cleaning sheet.
Adjust the colorimeter unit.
☞35100
Clean the calibration plate.
Replace the calibration plate if it is scratched on.
☞27470
Colorimeter unit ☞27470
Processor control PCB
☞66200
Problems may occur if the process of performing morning daily setup, then performing Emulsion Number
Change on the main paper when the air temperature has risen, is repeated for several days.
In that case, perform the paper specification registration setup, then perform the paper magazine registration setup
of other magazines.
Countermeasure and failed part Manual No.
Laser control PCB ☞66010
Laser unit
☞63080
Problems may occur when the processing solution (CD) has been replaced.
In that case, perform the paper specification registration setup, then perform the paper magazine registration
setup of other magazines.
Countermeasure and failed part Manual No.
Distributed by: minilablaser.com
To Next Page
Loading...