Attention message: Disk/Media
1/1
4. Troubleshooting
41500
41500
Attentio n message: Dis k/Med ia
No. 01501−01549
See the EZ Controller Troubleshooting Manual for Corrective action of Attention
message.
Condition
IMPORTANT
• Attention messages not explained in this Service Manual are listed in the table.
See the EZ Controller Troubleshooting Manual for Corrective action of Attention message.
Attention message (Storage Media)
NOTE
• In the Attention message table, attention message numbers that are not used currently may be listed.
Attention message table
No. 01501 The media is write protected.
No. 01502 Replace the media.
No. 01503 The appropriate file was not found.
No. 01508 There are some files that could not get written to the media. Would you like to stop processing?
No. 01510 Read the data. Set the media.
No. 01511 Write the data. Set the media.
No. 01512 Data was not read from the media.
No. 01513 Data was not written to the media. Format the media?
No. 01515 Data is too large to write.
No. 01516 Data is too large to read.
No. 01517 Invalid image format. Failed to read.
No. 01519 Data has been written to this media. Would you like to delete all the written files?
No. 01520 Select the template.
No. 01521 Template information does not match to make the Album Print.
No. 01522 Are you sure to print the previous frame except selected one?
No. 01523 It was not registered as an option.
No. 01528 Registered Print Type of Print Channel is not for normal printing.
No. 01529 Failed to read the bar code.
No. 01530 The data was not written to the Network Folder. Make sure a Network Folder exists.
No. 01531 The data was not written to the Network Folder. Make sure the Network is connected.
No. 01533 Data was saved to the storage media.
No. 01534 Data was not written to the Hard Disk. Would you like to delete the image file(s)?
No. 01536 The data has already been written to this media. Format this media?
No. 01537 The appropriate file was not found.
No. 01539 The data has already been written to this media. Set a new media.
No. 01540 Data could not be written to the media. Confirm the media drive setting.
No. 01542 The same order number data already exists. Would you like to overwrite?
No. 01543 This file is CMYK data. Color cannot be converted correctly. Would you like to read the data?
No. 01545 The image size aspect ratio is not correct. Data was not written.
No. 01546 Data could not be written to the media. Confirm that the media capacity matches the Media Capacity Setting.
No. 01547 Data was saved to the storage media. Remove the media.
No. 01548 Hard disk is full. Would you like to delete the image file(s)?
No. 01549 Data is too small to read.
Distributed by: minilablaser.com
To Next Page
Loading...