8/14
4. Troubleshooting
45530
45530
Error: Processor 2
No. 05538
Backup data error. Processor
Error message release
NO
Condition
NOTE
• The value informed from CPU is displayed in the last three digits of the suffix number.
• If approximately 5 days have passed with the power supply being off or if the processor control PCB has been replaced with a new
one, this error message is shown.
IMPORTANT
• If the error message above is shown, the backup data for the processor control PCB saved in the printer I/F main PCB is
sent to the processor control PCB within approx. 5 to 10 minutes while the error cannot be canceled.
If the backup data is sent normally, the error above can be closed.
However, the backup data saved in the printer I/F main PCB may have a problem. If the error above occurs, we
recommend you to read the backup data on the media saved at the close down check.
Diagnosis
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
Suffix number Condition
0### The backup data of the processor control PCB is abnormal.
1### The backup data of the printer I/F main PCB and processor control PCB.
If the data was deleted Manual No.
Carry out Reading data. ☞35400
Only for F specification, the error message
☞No. 05905[F], ☞No. 05906[F], or ☞ No. 05907[F] may appear in
specific condition.
☞57020
Failed part Manual No.
Processor control PCB
☞66200
Printer I/F main PCB ☞66005
Distributed by: minilablaser.com
To Next Page
Loading...