4. Troubleshooting
46200
2/21
46200
Error message: Printer 3
If the test print color density is abnormal
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
#2006 Problems may occur if the process of performing morning daily setup, then performing
Emulsion Number Change on the main paper when the air temperature has risen, is repeated for
several days.
In that case, perform the paper specification registration setup, then perform the paper
magazine registration setup of other magazines.
−
Process the control strip and check the condition of the processing solution. −
Suffix
number
Countermeasure and failed part Manual No.
#2001
#2004
#2005
#2006
G-AOM driver ☞66080
Laser control PCB ☞66010
Laser unit ☞63080
#2004 It may occur when the contamination has occurred.
Process the control strip and check the condition of the processing solution.
−
#2005 Problems may occur when the processing solution (P1) has been replaced.
In that case, perform the paper specification registration setup, then perform the paper
magazine registration setup of other magazines.
−
Suffix
number
Countermeasure and failed part Manual No.
Distributed by: minilablaser.com
To Next Page
Loading...