A320 Neo Instructor Operating Station
Instructor User Guide
REFERENCE AIRPORT Tab
13 Oct 2017
Page 152
If a landing profile is tagged as being a QTG Windshear, then selecting that profile
enables the QTG Intensity button.
The QTG Intensity button causes the simulator environment (A/C gross weight, fuel
weight, CG, temperature, pressure, CG, windshear intensity) to be set as per the
associated QTG Windshear landing case.
9.13.3.9 Intensity Buttons
The non-predictive windshear intensity buttons are mutually exclusive.
9.13.3.9.1 Light
Tap this button to set the non-predictive windshear profile intensity to light.
9.13.3.9.2 Moderate
Tap this button to set the non-predictive windshear profile intensity to moderate.
9.13.3.9.3 Severe
Tap this button to set the non-predictive windshear profile intensity to severe.
9.13.3.9.4 QTG
Tap this button to indicate that the QTG wind shear will be used when the selected
windshear is activated. This button is only available when a QTG windshear is
selected.
9.13.3.9.5 QTG Flag
A green QTG flag next to a windshear profile indicates that this profile was used for
the QTG tests.
9.13.3.10 Turbulence
This read-only field displays the nominal intensity of the enabled turbulence.
9.13.3.11 Activate NP Windshear
Tap this button to activate the selected non-predictive windshear profile. This button
is disabled when a windshear profile is activated.
9.13.3.12 Clear Windshear
Tap this button to deactivate the active non-predictive windshear profile. This button
is disabled when no windshear profile is activated.
To Next Page
Loading...