Instructor User Guide
Control Board Footer
Control Board Footer
13 Oct 2017
Page 173
11.2.6.1.1 End Lesson
Tap this button to end the current in progress lesson plan. This causes the master
index panel to be displayed. This button is disabled when there is no active lesson
plan.
11.2.6.1.2 Crash Inhibit
Tap this button to prevent a crash from occurring when crash limits are exceeded.
This means that the simulation will continue through a crash.
When this button is not selected, in the event of crash situation, the simulation will
freeze, except for:
• Advisory crashes or exceedance advisories
o Where only the Crash/Advisory/Exceedance panel appears, but the
simulation does not freeze
The following parameters are monitored to detect an aircraft crash condition:
• Excessive rate of descent at touchdown
• Wing strike on ground (advisory)
• Tail strike (advisory)
• Landing gear not down and locked at touchdown (advisory)
• Excessive side force on ground
• Excessive speed
• Excessive G force
• Excessive Mach
• Ground contact off runway (advisory)
• Midair collision
• Terrain/Obstacle impact
• Structural impact off runway
• Excessive speed (> 75 kt) off runway
• Excessive flight acceleration in air (exceedance)
• Excessive jerk (rate of change of acceleration) in air (exceedance)
• Unstable flight acceleration in air (exceedance)
• Excessive flight acceleration on ground (exceedance)
• Excessive jerk (rate of change of acceleration) on ground (exceedance)
• Unstable flight acceleration on ground (exceedance)
To Next Page
Loading...