FSC A320 - Intruder Transponder Equipment; Ownship Capacity Limitation

A320 Neo Instructor Operating Station
Instructor User Guide
Advanced
13 Oct 2017
Page 256
16.4.1.1.4 INTRUDER TRANSPONDER EQUIPMENT Section
This section includes checkboxes allowing the instructor to set the interrogation mode
of the intruder transponder(s).
16.4.1.1.4.1 Altitude Reporting
The Altitude Reporting check box has two statuses:
Checked
This sets the transponder mode of intruders in Mode C/S which
causes the transponder of intruders to transmit their altitude. In this
mode, TCAS will issue Traffic Advisory and Resolution Advisory
if any.
Unchecked
This sets the transponder mode of intruders in Mode A which
causes the transponder of intruders to not transmit their altitude.
On the TCAS display, the intruder symbol will be shown without
any altitude tag. Therefore, no Resolution Advisory is issued by
TCAS.
16.4.1.1.4.2 ADS-B Reporting
The ADS-B Reporting check box has two statuses:
Checked
This allows the transponder of intruders to transmit their ADS-B
information such as position, speed and direction of flight (latitude,
longitude, vertical speed etc). When ADS-B is checked, ADS-B is
being reported.
Unchecked
This does not allow the transponder of intruders to transmit their
ADS-B information. When ADS-B is unchecked, ADS-B is not
being reported.
16.4.1.1.5 OWNSHIP CAPACITY LIMITATION
This section includes a checkbox allowing or inhibiting bearing measurement from
the TCAS antennas.
16.4.1.1.5.1 No Bearing Data Measured
The No Bearing Data Measured check box has two statuses:
Checked
This inhibits the bearing measurement from the TCAS antennas.
Unchecked
This allows the bearing measurement from the TCAS antennas.