408 Upgrade and Maintenance Manual RX2530 M4
System board and components
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the Global Error indicator stops flashing.
Ê "Resuming BitLocker functionality" on page 98
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 401.
Ê If applicable, restore LAN teaming configurations, see section "After
replacing a system board" on page 105.
To Next Page
Loading...
