GE MAC 5 A4

Configure Settings
Table 47: Configure a DCP Server Destination to Send Reports
Field Name Action Description
Destination
Name
Enter the name of the DCP server destination
where the reports will be sent.
A user-defined value
up to 20 characters.
Allowed values:
• A to Z
• a to z
• 0 to 9
• All special
characters
Server Name Enter the URL of the DCP server.
NOTE:
• Make sure that you append ‘/SendTest’
to the URL. For example, http://
<IP_Address> or <Hostname>:<Port>/
SendTest.
• Confirm that the URL for the server is
correct.
• Confirm that the DCP server is running.
• Make sure that you enable ADT for DCP
communication, configure the same IP
address for the DCP destination and the
MUSE Orders Server for remote query.
A user-defined value.
Allowed values:
• A to Z
• a to z
• 0 to 9
• All special
characters
ADT Query Enable or disable this setting. If this setting
is enabled, the
destination is
configured to perform
ADT query.
Default value: Disabled
5. Select Test Connection.
• If the test displays Test Successful, you have a successful connection to that
destination. Select Add to save the destination.
• If the test displays Test Failed, you do not have a connection to that
destination. Troubleshoot the connection failure depending on the error, re-
test and add the connection.
6. Select Save.
7. Repeat steps 2 to 6 to add more DCP server destinations.
8. To edit an existing DCP server destination:
a) Select anywhere in the row of the destination you want to modify to enable
the edit mode.
5864335-001-1  MAC
™
5 A4/MAC
™
5 A5/MAC
™
5 Lite 169