GE Multilin F650 Digital Bay Controller 5-77
5 SETPOINTS 5.5 CONTROL ELEMENTS
5
5.5CONTROL ELEMENTS
The F650 incorporates the following control elements:
setpoint Group
Underfrequency
Overfrequency
Synchrocheck (25)
Autoreclose (79)
Breaker Failure (50BF)
Broken Conductor (I2/I1)
Note: for all control elements related to the breaker, it must be considered that all operations will be performed considering
the status of the switchgear configured as breaker. In setpoint > Relay Configuration > Switchgear up to 16 switchgear
elements can be configured to operate and be monitored, but only one of them can be configured as breaker, for
monitoring, number of openings and closings counters, (KI)
2
t.
5.5.1 SETPOINT GROUP
The setpoints used for setpoint table management are located in Setpoint >Control Elements > setpoint Group:
Table 5–68: SETPOINT GROUP SETPOINTS
The snapshot event setpoint enables or disables the snapshot event generation for this unit.
For more detail information go to section 5.4.1
SETPOINT > CONTROL ELEMENTS > SETPOINT GROUP
SETPOINT DESCRIPTION NAME DEFAULT
VALUE
STEP RANGE
setpoint Grouping Permission Function DISABLED N/A [DISABLED – ENABLED]
Active Group Active Group GROUP 1 N/A [GROUP 1 – GROUP 2 – GROUP 3]
Snapshot Event generation Snapshot Events ENABLED N/A [DISABLED – ENABLED]
To Next Page
Loading...
Need help?
General
