GE Multilin F650 Digital Bay Controller 5-107
5 SETPOINTS 5.6 INPUTS/OUTPUTS
5
5.6.4.2 OUTPUT STATUS SIGNALS
Boards types 1 and 2 have both 8 outputs, so the representation is the same for both types as shown in .
Actual > Inputs/Outputs >Contact Output Status
Real status of the contact output, which corresponds to the transformation of the output activation signal (Contact output
operate), by the logic applied to this output in “Setpoint > Inputs/Outputs >Contact I/O > Board X”
Actual > Inputs/Outputs > Contact Output Operates
Activated or deactivated status of those variables used internally to operate a contact output.
Actual > Inputs/Outputs > Contact Output Resets
These are the logic signals associated to the contact output reset, which produce the reset of those signals previously
configured as Latched. Configuration for the contact output reset signal is set at Setpoint > Relay Configuration >
Outputs > Contact Output Reset.
Actual > Inputs/Outputs >I/O Board Status
These signals are associated to the different I/O boards. There are internal signals that provide information about the status
of these boards, indicating whether there is any anomaly in the board, or whether the board is not available in the relay
according to the relay model.
Table 5–88: CONTACT OUTPUT SIGNALS
Being X the corresponding board in each case
CONTACT OUTPUT STATUS CONTACT OUTPUT OPERATES CONTACT OUTPUT RESETS IO BOARD STATUS
CONT OP_X_01 CONT OP OPER_X_01 CONT OP RESET_X_01 BOARD F STATUS
CONT OP_X_02 CONT OP OPER_X_02 CONT OP RESET_X_02 BOARD G STATUS
CONT OP_X_03 CONT OP OPER_X_03 CONT OP RESET_X_03 BOARD H STATUS
CONT OP_X_04 CONT OP OPER_X_04 CONT OP RESET_X_04 BOARD J STATUS
CONT OP_X_05 CONT OP OPER_X_05 CONT OP RESET_X_05
CONT OP_X_06 CONT OP OPER_X_06 CONT OP RESET_X_06
CONT OP_X_07 CONT OP OPER_X_07 CONT OP RESET_X_07
CONT OP_X_08 CONT OP OPER_X_08 CONT OP RESET_X_08
To Next Page
Loading...
Need help?
General
