GE Multilin F650

GE Multilin F650 Digital Bay Controller 8-3
8 BOOTCODE AND FIRMWARE UPDATE 8.1 INTRODUCTION
8
In the case of relay that has updated previously its Bootcode (Sections 2), the IP address already has been assigned in the
previous process (see figure 8-14).
In both cases, it is necessary to check that there is no other equipment connected with the same IP address in the same
net, to avoid collision.
In case of a back-to-back connection from a PC to the relay (through a crossover Ethernet cable), the IP address of the
relay needs to be compatible with the TCP/IP configuration of the computer.
For example, if the relay settings are:
IP address: 192.168.37.240,
Netmask: 255.255.255.0 and
Gateway: 192.168.37.10.
The computer settings have to follow the model:
IP address: 192.168.37.XXX
Netmask: 255.255.255.0 and
Gateway: 192.168.37.10 (if desired).
XXX is a number between 0 and 255 that is not assigned to any other device to avoid collisions.
If there are not TCP/IP settings according to this model in the computer, it should be added (in order to communicate with
the relay) following these steps:
Go to the Control Panel of the computer and select the Network option (the name of this option may depend on the PC
operative system).
Figure 8–2: NETWORK IN CONTROL PANEL
In Network, enter in Protocols and select TCP/IP protocol by clicking on P
roperties.