GE Vivid S5 N - Page 193

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-117
PRELIMINARY
The Internet Protocol (TCP/IP) Properties dialog box opens.
10.)Activate the Use the following IP address check box.
11.)Type in the Vivid S5 N or Vivid S6 N IP address 10.0.0.1 or the one provided by the local network
administrator.
Note: The IP must be different from the IP address used for network computer.
12.)Type in the Subnet mask 255.255.255.0 or the one provided by the local network administrator.
Note: The Subnet mask should be the same for both the network computer and the Vivid S5 N or
Vivid S6 N.
13.)Click OK
14.)Press the Config button on the control panel to close all windows and return to the regular scanning
mode.
NOTE: The following steps are performed on the Network Computer.
1) On the network computer, access the Control Panel, as follows:
a.) Double-click on My Computer icon on desktop.
b.) Double-click on Control Panel icon.
2) Double-click on Network Connections icon.
3) Double-click on Local Area Connection icon.
Figure 3-137 Internet Protocol (TCP/IP) Properties