GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
4-6 Section 4-2 - General Procedures
PRELIMINARY
4-2-2 Power ON/Boot-up (cont’d)
c.) The Back-End Processor and the rest of the scanner commences the following sequence (in
the listed order of steps):
1.) Back-End Processor is turned ON and starts to load the software.
2.) The Start Screen is displayed on the monitor (Figure 4-5 "Start-up Screen" on page 4-6).
3.) A start-up progress bar indicating the time used for software loading, is displayed.
4.) The software initiates and sets up the Front-End electronics and the rest of the scanner.
5.) The Keyboard backlight illuminates.
6.) As soon as the software has been loaded, a 2D screen is displayed on the monitor, as
shown below.
NOTE: Total time used for start-up is typically 3 minutes.
Figure 4-5 Start-up Screen
Figure 4-6 2D Screen
To Next Page
Loading...
