GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
7-88 Section 7-4 - Performing Front End (FE) Diagnostics
PRELIMINARY
As the testing sequence progresses, the progress bar will advance to reflect the test progress.
Status indicators in the Data Flow map corresponding to the various system components will be
highlighted in the appropriate color to indicate the current test status, as follows:
• Green: All recommended tests for these components have been completed and no problems
were identified.
• Red: Problems were identified in these components during the performance of the test.
• Yellow: The tests executed so far on these components have passed, but not all
recommended tests have been performed.
6.) At any stage, trackball to the Pause button and press Set, if required.
7.) To resume testing (from the point where you paused), trackball to the Start button and press Set.
When the Pencil RX Test sequence is complete:
- the Diagnostic Test window displays the Finished message
- the View Test Log window opens automatically, listing all tests performed and showing details
of which tests passed or failed, as shown in the example in Figure 7-57 - View Test Log -
Pencil RX Test.
NOTE: The Pencil RX Test has one test report which is listed in Reports on the right and displayed in
the Reports window below (Figure 7-57 "View Test Log - Pencil RX Test" on page 7-88).
8) When finished reviewing the first report, trackball to the Exit button and press Set to close the View
Report window.
9) After reviewing the test results, proceed as follows:
• If no problems were identified, it is recommended to re-boot the system (this is obligatory when
prompted).
• If no problems were identified but the problem persists, contact your local GE HEALTHCARE
Figure 7-57 View Test Log - Pencil RX Test
To Next Page
Loading...
